9
ADJUSTING THE AIR FLOW DIRECTION
Make sure that the remote control unit has been turned on. Press
the FLAP button to select the sweep function or to choose one
of the six positions of the flap.
CAUTION
Do not move the flap with your hands when the air conditioner
is running.
Sweep function
The flap starts moving up and down to deliver air over the
sweep range.
NOTES
•
The flap automatically closes when the unit is off.
• During the heating operation, the fan speed will be very low
and the flap will be in the horizontal position (position
4
) until
the air being blown out of the unit begins to warm. Once the
air warms up, the flap position and fan speed change to the
settings specified with the remote control.
• Use the FLAP button on the remote control to adjust the
position of the flap. If you move the flap by hand, the factual
flap position and the flap position on the remote control
may no longer match. If this should happen, shut off the
unit, wait for the flap to close, and then turn on the unit
again; the flap position will now be normal again.
CAUTION
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION BUTTON until the OPERATION lamp is
turned off.
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION BUTTON to select the desired mode (COOL
or HEAT).
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
TIPS FOR ENERGY SAVING
DO NOT:
l
Block the air intake and outlet of the unit.
If they are obstructed, the unit will not work well, and
may be damaged.
l
Let direct sunlight into the room. Use sunshades,
blind or curtain.
DO:
l
Always try to keep the air filter clean. A clogged filter
will impair the performance of the unit.
l
To prevent conditioned air from escaping, keep
windows, doors and any other openings closed.
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after
3 minutes.
NOTE
Operation
button
To access the button it is
necessary to remove the
bottom panel.
EN
