OpenTracker USB User’s Manual
29
RETRYTIME
<0-255> (seconds)
Time between message retry attempts - interval increases by this value
with each transmission.
REQALL
on|off
Require all configuration switch parameters to be met before switching
profiles.
RESET
Perform software reset. Saved settings are unaffected.
RING
on|off
Sends a bell character whenever an incoming message arrives.
SCRIPT
on|off
Enables the script engine.
SECRET
<pass phrase>
Sets the pass phrase for the one-time password authentication system.
SEND
<callsign> <message>
(local only)
Sends a text message to the designated recipient.
SHAREDPTT
on|off
Controls PTT line behavior for mic encoder mode. If enabled, PTT output
is not asserted until the PTT input is released.
SLOT
<0-65535>
Time slot for transmission (if
TIMESLOT
is on). Slot position is counted in
seconds from the start of the hour.
SMARTBCON
<low speed> <high speed> <low rate> <angle> <time>
Configures SmartBeaconing. The SmartBeaconing algorithm allows the
tracker to operate more efficiently by changing how often it transmits
depending on its speed and turn rate.
When stopped or moving at a speed below the low speed setting, the
tracker will transmit at a fixed rate determined by the lower rate setting.
Above the specified high-speed threshold, the higher rate setting is used.