QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.com
11
Remove the fuselage canopy hatch,
slide the Li- Po into the front section
of the fuselage and secure it to the
battery mounting platform using
the hook and loop tape supplied.
12
Remove the transmitter battery
cover and insert four AA alkaline
cells taking care to observe the
correct polarity.
13
Switch ON your transmitter and
ensure the LED is lit solid green.
Keep the throttle stick at its low
position.
Important: Do not adjust the digital trims
while switching on the transmitter as these
are used in the servo reversing procedure.
See the full manual online for details.
14
Connect the battery to the Electronic Speed
Controller (ESC). An series of 3 audible beeps will
be heard indicating that the ESC is armed and
operational. Stow the leads within the fuselage
and replace the canopy hatch.
In the unlikely event that the servos do not
operate, see the PAIRING instructions at the back
of this guide
.
Place the charger on a flat, heat resistant surface
with a good airflow all around. Connect the supplied
3S 1500mAh Li- Po battery to the charger using
the white three pin balance plug, ensuring the
correct orientation of the plug. The red ‘Charger’
LED will light indicating that the battery is charging.
When fully charged the red LED will stop glowing,
whereupon the battery can be disconnected.
10
