7/8
USER'S MANUAL
Dimming/Switch Setting
Press
DMX
button into DMX status.
Press and hold the
FNC
button for 3 seconds.
The default setting for all channels (AL) is
dimming mode (=d).
Press
FNC
button to select channel.
Press ▲ or ▼ to select dimming mode (=d) or
switch mode (=S).
WarmUp Setting (0 – 6%)
Press
FNC
button. The default setting for all
channels (A) is no preheat (00).
Press
FNC
button to select the channel, ie select
channel 1
Press ▲ or ▼ to adjust. The warmup level can
be adjusted from 1% to 6%.
Channel Output Status Preview
Enter to DMX status and press
DMX
button.
Press ▲ or ▼ to preview.
Manual Dimming
Move the sliders
VR1
VR6
to dim the intensity of
the corresponding output channel.
When a DMX signal input from a console is also
present, the corresponding output channel will
take the higher value between DMX signal and
slider value.
When the dimmer pack is receiving a DMX frame,
if the signal is lost (or the cable is disconnected)
the outputs will take the value set by the sliders.
Also, if the projector is turned on and it is not
connected to a valid DMX signal, the light intensity
is brought to the levels set by the sliders.
Display the Dimming Value of DMX Channel
and Internal Temperature
Press
L
button to display the dimming value of
DMX channel.
Press
T
button to display the internal temperature.
DMX512 Status & DMX512 Address
Press
DMX
button to DMX status.
The LED will return to DMX status after 10
minutes idle.
Protocol Control
When the protocol control turns on, it only
receives the DMX signal whose break width
ranges from 88μs to 230μs.
Press
FNC
button to enable or disable the
protocol control.
Press ▲ and LED displays as below, protocol
control is ON.
Press ▼ and LED displays as below, protocol
control is OFF.
