Original User Manual
–
A
REBO
S Spa Pool Copenhagen/ Bora Bora
14
water back to 1°C above selected temperature. Once achieved, heater will stop to allow
temperature to settle at pre-set value.
5.4 Filtration System
•
Press
FILTER
, red light will appear, pump will start to work. Press
FILTER
again to stop pump,
red light will go out.
•
After approx. 168 hours,
FC
will appear on display screen (flashing) with a warning tone. Red
light will be lit on
FILTER
, pump
will not
be operational. Heating system will also not work
and red light will be off.
•
To make sure filtration system is off, press
FILTER
.
FC
on display screen will disappear as well
as warning tone. Water temperature will be displayed, all functions will return to normal.
FC
and warning tone remind user to replace filter.
6. Maintenance and Repair
Water level
Water should be filled and mainta
ined between “Min” and “Max” fill lines as indicated on inner wall
of your spa.
Importance of water treatment
You need to regularly monitor and appropriately treat the water in your spa.
People with the following traits are at higher risk including:
−
Diabetes, lung and heart disease
−
Smokers and heavy drinkers
−
Anyone with an impaired immune system
−
People suffering from chronic respiratory or kidney disease.
For more information contact your doctor.
Water and legionnaires disease?
Legionnaires’ disease can be c
ontracted by inhaling small droplets of water (called aerosols), which
are suspended in the air and contain the bacteria. Certain conditions increase the risk of Legionella if:
−
Water temperature in all or some parts of the system is between 20-45°C, which is suitable
for growth of the bacteria.
−
It is possible for breathable water droplets to be created and water is stored and/or re-
circulated.
−
There are deposits that can support bacterial growth providing a source of nutrients for the
organism e.g. rust, sludge, scale, organic matter and biofilms (from the body).
Cleaning
Detergent residues, dissolved solids from bathing suits and chemicals will gradually accumulate in the
water. To clean your spa, use soap and water then rinse thoroughly.
Please note:
do not use hard brushes or abrasive cleaners.
Repairing punctures
If your spa is torn/punctured, use repair patches. Completely dry area to be repaired, apply strong
adhesive to repair patch and then cover the damaged area. Smooth the surface to remove any air
bubbles. Leave to dry for 12 hours before using the spa.
