Arctiko CRYO 170, Operating Instructions Manual, Page: 20 / 40

GB
19
Changing the Chart
The chart is removed by first lifting the pen arm then using your thumb and fore
fingers push the retaining toggle to the open position (diagram 1). Lift the toggle
upright position (diagram2), Remove and replace the chart taking care to ensure the
chart goes behind the two chart guides. Rotate the chart anti-clockwise until the
pen nib is approximately 10mm to the left of the start point. Lock the chart by pushing
the toggle back to the center position (diagram 3) Lower the arm so that the pen
nearly touches the chart and use the chart advance button to align the pen with the
start position. Then release the pen arm.
Changing the pen
Gently lift the pen arm then pull the pen nib off in the direction of the arm taking
care not to twist the arm on its spindle. Replace with a new pen.
1.1 Pen Alignment
It is recommended that this procedure is carried out whenever the pen nib is
changed or at any time if it is suspected that the pen arm has been forced out of
position by rough handling.
1. Start with Rotation Switch set to 1 (see diagram overleaf)
2. Set S1 ON
3. Set Rotation to 0
(Sounds "dah dit dah dit" C for align)
4. Press HI until the pen is at the outer edge of chart (HI &LO to fine adjust)
5. Press ACCEPT
(Sounds "dit dah" A for Accept)
6. Press LO until the pen is at the inner edge of chart (HI &LO to fine
adjust)
7. Press ACCEPT
(Sounds "dit" E for END of alignment)
(Pen will now return to indicate temperature)
8. Return Rotation Switch to the required chart speed
9. Set S1 OFF
Note all modes timeout after 30 seconds of inactivity, if the setting mode is lost then return
Rotation SW to 1 then 0 to restart the setting procedure