5. GETTING STARTED
5-1. Start Up
1.) Once all connections are made, circulate water through chiller before turning on the unit.
2.) Check all connections for leaks.
3.) Verify electricity rating, and then plug power cord into a dedicated electrical outlet.
4.) This unit has been factory-set at 77
¢ .
5.) The Digital Display will read the current water temperature.
6.) The light indicator will begin to blink.
7.) Chiller will automatically turn on within 3 minutes.
8.) Your chiller has now been activated.
* This unit contains an Auto Digital Temperature Control System. This built-in thermostat will
turn itself on/off /-1
¢
according to the desired set temperature.
* Erro representationl
The thermostat has self-diagnostic funcition, so the letters below will be appeared display
if error occurs
Indication
Descriptions
Overcooling
Short circuit
Short circuit
Abnormal signal
of sensor
Please try to check and repair it following instructions below.
Otherwise, contact us for warranty service.
Please check it if the water temperature is below -5
¡
(celsius degree)
the sensor is out of order, or there is bad connetion before repairing.
Please check it if there is short circuit due to pressed or torn sensor
wire before repairing.
Please check it if the sensor wire is disconnected before repairing.
Please check it if there is any damage to the sensor wiring.
or water soaked into the joints before repairing.
Changing setting temperature
Example: To change setting temperature rang from 77
¢
to 79
¢
Press the UP button
for 5 seconds.
The Decimal Point will
blink. Depress the UP
button once the number
starts to blink.
Set to desired temperature
setting by pressing UP or Down
buttons.
The new temperature setting
will blink and be stored in the
memory chip after 10 seconds.
- 6 -
