2-3
2
Lubrication Points
It is advisable to lubricate certain components peri-
odically to ensure free movement. Apply light oil to
the components using the following list as refer-
ence.
A. Throttle Lever Pivot/Cable Ends
B. Brake Lever Pivot/Cable Ends
C. Brake Cable Ends
D. Idle RPM Adjustment Screw (Carburetor)
Battery
The battery is located under the seat.
After being in service, batteries require regular
cleaning and recharging in order to deliver peak per-
formance and maximum service life. The following
procedure is recommended for cleaning and main-
taining a sealed battery. Always read and follow
instructions provided with battery chargers and bat-
tery products.
1. Remove the battery hold-down; then disconnect
the battery cables (negative cable first).
2. Remove the battery from the battery compart-
ment; then thoroughly wash the battery and bat-
tery compartment with soap and water.
NOTE: If battery posts, cable ends, or the battery
case has a build-up of white/green powder resi-
due, apply water and baking soda to neutralize
acid; then flush off with warm soapy water.
3. Using a wire brush, clean the battery posts and cable
ends removing all corrosive buildup. Replace damaged
cables or cable ends.
4. Using a multimeter, test the battery voltage. The
meter must read at least 12.5 DC Volts for a
fully charged battery.
NOTE: At this point if the meter reads as specified,
the battery may be returned to service (see step 8).
5. If the meter reads less than specified voltage,
charge the battery using the following guide-
lines.
A. When using an automatic battery charger,
always follow the charger manufacturer’s
instructions.
B. When using a constant-current battery
charger, use the following Battery Charging
Chart.
NOTE: If the battery voltage is 11.5 DC Volts or
less, some chargers may “cut off” and fail to
charge. If this occurs, connect a fully charged
booster battery in parallel (positive to positive and
negative to negative) for a short period of time
with the charger connected. After 10-15 minutes,
disconnect the booster battery leaving the charger
connected and the charger should continue to
charge. If the charger “cuts off,” replace the bat-
tery.
6. After charging the battery for the specified time,
remove the battery charger and allow the battery
to sit for 1-2 hours.
! WARNING
Anytime service is performed on a battery, the fol-
lowing must be observed: keep sparks, open flame,
cigarettes, or any other flame away. Always wear
safety glasses. Protect skin and clothing when hand-
ing a battery. When servicing battery in enclosed
space, keep the area well-ventilated.
! CAUTION
Do not remove seal strip.
! WARNING
Battery acid is harmful if it contacts eyes, skin, or
clothing. Care must be taken whenever handling a
battery.
! CAUTION
Never exceed the standard charging rate.
! WARNING
An overheated battery could explode causing severe
injury or death. Always monitor charging times and
charge rates carefully. Stop charging if the battery
becomes very warm to the touch. Allow it to cool
before resuming charging.
Battery Charging Chart (Constant-Current Charger)
Battery Voltage
(DC)
Charge
State
Charge Time Required
(at 1.5-2.0 Amps)
12.5 or more
100%
None
12.2-12.4
75%-99%
3-6 hours
12.0-12.2
50%-74%
5-11 hours
11.0-11.9
25%-49%
13 hours (minimum)
11.5 or less
0-24%
20 hours (minimum)
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
