2-9
2
KM038A
4. Install the drain plug and tighten to specifica-
tions (see Section 10). Pour the recommended
lubricant in the fill/level hole. Install the
level/fill plug.
5. Start the engine (while the ATV is outside on
level ground) and drive it a short distance.
6. Turn the engine off and wait approximately one
minute. Remove the level/fill plug and recheck
the lubricant level. The level should be visible at
the level hole. If lubricant is not visible, add rec-
ommended lubricant until the level is visible at
the level hole.
7. Inspect the area around the drain plug for leaks.
Engine Oil
1. Move the ATV outdoors and start and warm up
the engine. Shut the engine off; then place a
drain pan under the engine oil drain plug located
on the left-side rear of the engine under the kick
starter.
CD634A
2. Remove the oil drain plug and drain the engine
oil into the pan; then install the oil drain plug
and tighten securely.
3. Move the drain pan to the right-front of the
engine and remove the oil screen/filter cap.
Account for a screen, spring, and O-ring.
KM040A
CD628
4. Clean the oil screen in parts-cleaning solvent
using a brush; then install the screen, spring, and
cap making sure the O-ring is seated properly in
the cap. Tighten to specifications (see Section
10).
CD626
5. Remove the oil level stick and pour the recom-
mended amount and viscosity oil into the
engine; then install the oil level stick.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
