Arctic Cat PROWLER 500 HDX, Operator'S Manual

Page: 54 / 68

52
6. Position the taillight/brakelight
assembly on the rear ROPS tube; then
tighten the mounting screws securely.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically
and horizontally. The geometric center of
the HIGH beam light zone is to be used
for vertical and horizontal aiming.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).
0740-647

NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark
5 cm (2 in.) below the horizontal
mark on the aiming surface.
7. Adjust each headlight until correct
aim is obtained, by turning the knob
clockwise to raise or counterclock-
wise to lower the beam.
CD714A
Fuses
The fuses are located in a power distribu-
tion module under the driver seat. If there
is any type of electrical system failure,
always check the fuses first.

NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift out.
3411-968
Electrical Output
Terminals
Two output terminals for electrical acces-
sories are located on the front and rear
wiring harnesses. Two accessory plugs
are located on the dashboard.

NOTE: The rear output terminal is
located near the left-side of the
throttle body. The front output termi-
nal is located beneath the dash-
board in front of the left-side
accessory plug.
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat dealer immediately.