18
0746-793
1. Remove the hairpin clip from the pin
located at the front of the access
panel. On the XF HC/M, remove the
thumb screw securing the front left
access panel to the front facia.
0749-028
2. Move the panel up and off the pin;
then swing the panel all the way out
and unhinge the panel from the
lower console.
3. Remove the torx-head screws secur-
ing the hood (located on the underside
of the hood above the front tube of the
upper A-arm); then remove the torx-
head screws from the top-side of the
hood securing the hood to the upper
console and the torx-head screws
from under the nosepiece of the hood.
4. Remove the intake panel below the
gauge; then locate the hood harness
connector (located in front of the
speedometer) and unplug the con-
nector; then move the hood slightly
forward and remove the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector making sure the harness
does not become pinched and the
mounting screw clips are in position.
NOTE: Make sure the hood tabs
are seated between the throttle body
boot.
2. Secure the hood with torx-head
screws and tighten securely.
3. Install the access panel onto the lower
console; then close the access panel
and secure with the hairpin clip and
thumb screw. Install the intake panel.
Removable Seat
ZR/XF
To remove the seat, remove the screw from
the underside of the seat; then lift on the
back of the seat and move it up and rear-
ward to remove it.
746-088A
To install the seat, route the front tab on
the seat through the seat-base hold-down
bracket; then install the seat and secure
using the cap screw.
SNO-273
NOTE: Prior to lowering and secur-
ing the seat, connect the seat heater
harness connector.
CAUTION
Prior to removing the seat, lift the rear
of the seat and disconnect the seat
heater harness connector.
