52
4. Install the rubber grommet; then
connect the headlight harness con-
nector to the bulb.
5. Check headlight aim (see Adjusting
Headlight Aim in this sub-section).
Adjusting Headlight Aim
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The geo-
metric center of HIGH beam zone is to be
used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).
NOTE: There should be an “aver-
age” operating load on the snowmo-
bile when adjusting headlight aim.
2. Measure the distance from the floor
to midpoint of the headlight.
3. Using the measurement obtained in
step 2, make a horizontal mark on
the aiming surface.
4. Make a vertical mark which inter-
sects the horizontal mark on the aim-
ing surface directly in front of the
headlight.
5. Engage the brake lever lock and start
the engine. Move the headlight dim-
mer switch to the HIGH beam posi-
tion. DO NOT USE LOW BEAM.
6. Observe the headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark
5 cm (2 in.) below the horizontal
mark on the aiming surface.
0745-813
7. Adjust the headlight using the
adjusting screw on the backside of
the headlight using a 4 mm swivel
socket and long extension until cor-
rect aim is obtained. Shut the engine
off; then disengage the brake lever
lock.
0746-807
Ski Wear Bars
The ski wear bar is a replaceable bar
attached to the underside of the ski. The
purpose of the wear bar is to assist in
turning the snowmobile, to minimize ski
wear, and to maintain good steering con-
trol. If the snowmobile is operated pri-
marily in deep snow, ski wear bar wear
will be minimal; however, if the snow-
mobile is operated on terrain where the
snow cover is minimal, the ski wear bar
will wear faster. To maintain positive
steering characteristics, Arctic Cat rec-
ommends that the ski wear bars be
checked before each use and replaced if
worn beyond 1/2 of the original diameter.
Ski wear bars are available from an
authorized Arctic Cat Snowmobile
dealer.
! WARNING
Do not operate the snowmobile
unless headlight beam is adjusted
properly. An incorrectly adjusted
beam will not provide the operator
the optimum amount of light.
! WARNING
Operating the snowmobile with
excessively worn ski wear bars may
result in a loss of steering control.
Summary of Contents for F 1100 series
Page 7: ...3 Snowmobile Safety Rules...
