11
At this point, the hours display will begin
to flash. Push the increment button to
increase the hours; push the decrement
button to decrease the hours. Pushing and
holding a button will accelerate the num-
ber display. When desired hour number is
displayed, push the select button.
At this point, the minutes display will begin
to flash. Push the increment button to
increase the minutes; push the decrement
button to decrease the minutes. Pushing and
holding a button will accelerate the number
display. When desired minute number is
displayed, push the select button.
NOTE: During clock setting if no
button (increment, decrement,
select) is pushed within a 5-second
time period, the clock-setting mode
will be exited with changes saved.
NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
To set/calibrate the altimeter to an estab-
lished altitude with altimeter selected on the
display screen by pushing and holding the
select button for a minimum of two seconds,
the acronym CAL will be displayed on the
readout screen for one second; then the alti-
tude value will flash. Push the increment
button to increase the displayed altitude;
push the decrement button to decrease the
displayed altitude. Pushing and holding a
button will accelerate the number display.
NOTE: If MPH has been selected in
the speed readout, the altitude value
will be displayed in feet. If kph has been
selected in the speed readout, the alti-
tude value will be displayed in meters.
To reset the maximum altimeter readout
with the maximum altimeter displayed,
push and hold the select button for a min-
imum of two seconds.
Service Icon
On electric start models, the icon should
briefly illuminate each time the key is turned
to RUN or START, and engine is started;
then it should go out when the engine starts.
If the icon stays illuminated (on electric start
models) or it illuminates while the engine is
running, the system is receiving input that is
outside of its established parameters.
If the icon illuminates indicating an error,
take the snowmobile to an authorized
Arctic Cat Snowmobile dealer for ser-
vice. If not under warranty, this service is
at the discretion and expense of the
snowmobile owner.
Coolant Temperature
Warning Icon
NOTE: On the 1100 cc models
when cold-starting the engine, the
coolant temperature warning icon
will illuminate, the readout screen
will display TEMP, and engine RPM
limit will be below drive system
engagement speed.
When the engine reaches proper operat-
ing temperature, the coolant temperature
warning icon and TEMP display will
cease to flash.
If the coolant temperature rises too far
above proper operating temperature, the
coolant temperature warning icon will
flash a warning (alert) and on the 1100 cc
models, the engine will “surge” to alert
the operator. If the coolant temperature
rises to a critical point above proper oper-
ating temperature, the coolant temperature
warning icon will cease flashing and will
remain constantly illuminated.
NOTE: On the 1100 cc models if
the coolant temperature icon is con-
stantly on, the engine will shut off if
vehicle speed is reduced to 1.5 kph
(0.9 MPH) or slower.
CAUTION
At this point, take precautionary mea-
sures such as changing to loose snow
terrain, shutting the engine off (allow-
ing the engine to cool down), and
checking coolant level. If unable to
either determine or remedy the prob-
lem, take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer for
service. If not under warranty, this ser-
vice is at the discretion and expense of
the snowmobile owner.
Summary of Contents for F 1100 series
Page 7: ...3 Snowmobile Safety Rules...
