Arctic Cat ATV 2005, Operator'S Manual

Page: 77 / 116

75
GENERA
L INFOR
M
A
T
ION
SEAT LATCH
(250/300)
738-443A
1. To remove the seat, pull the seat
latch lever forward (located below
the right side of the seat). Raise the
front end of the seat and slide it
forward.
2. To lock the seat into position, slide
the rear of the seat into the seat
retainers and push down firmly on
front of seat. The seat should auto-
matically lock into position.
SEAT LATCH
(400 FIS/ACT)
1. To remove the seat, push the seat
latch lever backward (located
under the rear rack near the front-
right rack mount). Raise the rear of
the seat and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
rear of seat. The seat should auto-
matically lock into position.
SEAT LATCH (400
TBX/500/650/650
V-Twin)
1. To remove the seat, lift up on the
latch release (located at the rear of
the seat); then raise the rear of the
seat and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
the rear of seat. The seat should
automatically lock into position.
TAILGATE LATCH (400
TBX/500 TBX)
739-569A
1. To open the tailgate, pull the latch
(located at the center of the tail-
gate).
2. To close the tailgate, press down
firmly. The tailgate will latch auto-
matically.
! CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
above the “L” mark but not higher
than the “F” mark.
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.