48
Seat Latch
XR254
1. To remove the seat, lift up on the
latch release (located at the rear of the
seat); then raise the rear of the seat
and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on the
rear of seat. The seat should automat-
ically lock into position.
Rear Seat Lock
1. To remove the rear seat, pull the two
latch handles upward.
XR221A
2. Lift the front of the seat up; then pull
slightly to the front and lift the seat
off the mountings.
3. To lock the seat into position, engage
the two rear mounting lugs into the
mounting rack; then push down
firmly on the front of the seat to
securely lock in place.
Safety Flag Bracket
A bracket is provided for mounting a flag
at the rear of the ATV.
Rack Loading (Front and
Rear)
The front rack and rear rack are designed
to carry specified load capacities. Always
refer to the ATV Load Capacity Ratings
chart for proper capacities.
Trailering and Towing
This vehicle is equipped with a frame-
mounted receiver for a standard 5.1 cm
(2 in.) receiver hitch. The standard
receiver hitch must be purchased sepa-
rately.
XR227
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.
! WARNING
Make sure the seat is secure before
mounting the ATV. Severe personal
injury may result if the seat is not
properly secured.
! WARNING
Make sure the loads on the front and
rear racks will not interfere with the
ATV controls or obstruct the view of
the operator. Also, make sure the
loads are evenly distributed, properly
secured, and will not shift while oper-
ating the ATV.
! WARNING
Never use the racks as a towing or
trailering point.
