51
KC0051A
4. Remove the drain plug from the bot-
tom of the engine and drain the oil
into a drain pan.
733-441A
5. Remove the oil filter plug from the
filter mounting boss (located on the
front-right side of the transmission
case) and allow the filter to drain
completely.
6. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil fil-
ter and dispose of properly. Do not
re-use oil filter.
NOTE: Clean up any excess oil
after removing the filter.
7. Apply oil to the new filter O-ring
and check to make sure it is posi-
tioned correctly; then install the new
oil filter. Tighten securely.
8. Install the oil filter drain plug and
tighten securely.
9. Install the engine drain plug and
tighten it securely. Pour ACX All-
Weather Synthetic oil in the filler
hole. Install filler plug.
10. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
11. Turn the engine off and wait approx-
imately one minute. Recheck the oil
level.
12. Inspect the area around the drain
plug and oil filter for leaks.
Front Differential and Rear
Drive Gear Lubricant
(Inspecting/Changing)
Inspect and change the gear lubricant in
each according to the Maintenance
Schedule. When changing the lubricant,
use approved SAE 80W-90 hypoid oil
and use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by remov-
ing in turn the drain plug from each.
CF107B
CF106C
4. After all the oil has been drained,
install the drain plugs and tighten
securely.
5. Pour recommended oil into each
filler hole.
CAUTION
Inspect the oil for any signs of metal
filings or water. If found, take the
ATV to an authorized Arctic Cat ATV
dealer for servicing.
Summary of Contents for ALTERRA 400
Page 75: ...73 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 76: ...74 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Page 77: ...75 NOTES...
Page 78: ...76 NOTES...
