Arctic Cat 2015 Pantera 7000, Service Manual

Page: 9 / 206

7
7000
Electrical Specifications
* Harness plugged in

NOTE: Lighting coil output is unregulated voltage.
Crankshaft Main Bearing Clearance 0.0007-0.0015”
Crankshaft/Rod Bearing Clearance 0.0016-0.0025”
Crankshaft Thrust Runout (max) 0.0043”
Crankshaft Main/Rod Journals (Bearing Surfaces) 0.0012”
Valve Guide Inside Diameter 0.2165-0.2170”
Valve Guide/Stem Clearance (max) (Int)
(Exh)
0.0015”
0.0022”
Valve Face Width 0.0197”
Valve Clearance - Cold (59°-77° F) (Int)
(Exh - 5000)
(Exh - 9000)
0.0039-0.0078”
0.0078-0.0118”
0.0118-0.0157”
Valve Seat Contact Width (Int/Exh) 0.0354-0.0433”
Valve Stem Diameter (Int)
(Exh)
0.2155-0.2161”
0.2147-0.2153”
ITEM
Engine Model Number 8JK
Displacement 1049 cc
Compression Ratio 11:1
Bore x Stroke 82.04 x 66.29 mm
(3.23 × 2.61”)
Cooling System Liquid
Spark Plug (NGK) CR9E
Spark Plug Gap 0.028-0.031”
Piston Skirt/Cylinder Clearance 0.0014-0.0024”
Piston Pin Diameter 0.7477-0.7480”
Piston Pin Bore Diameter 0.7482-0.7486”
Piston Pin to Piston Pin Bore Clearance 0.0002-0.0009”
Connecting Rod: Small End Diameter 0.7482-0.7491”
Crankshaft Pin/Connecting Rod Big End Clearance 0.0013-0.0020”
Connecting rod: Big End Diameter 1.6142-1.6149”
Piston Ring End Gap (Top)
(2nd)
(Oil)
0.013-0.018”
0.028-0.033”
0.008-0.024”
Piston Ring/ (1st - Top)
Groove Clearance (2nd)
(Oil)
0.0012-0.0028”
0.0008-0.0024”
0.0016-0.0043”
Piston Diameter
(11 mm from bottom edge) 3.2264-3.2270”
Cam Lobe Height (Intake) 1.3484”
Cam Lobe Height (Exhaust) 1.3327”
Cam Lobe Width (Intake/Exhaust) 0.9783”
Camshaft Journal Diameter 0.9630-0.9635”
Camshaft Journal Clearance 0.0011-0.0024”
Crank Pin Diameter 1.4951-1.4961”
Crankshaft Runout (max) 0.012”
Crankshaft Main Bearing Clearance 0.0011-0.0018”
Crankshaft/Rod Bearing Clearance 0.0013-0.0020”
Valve Guide Inside Diameter (Intake) 0.1762-0.1768”
Valve Guide Inside Diameter (Exhaust) 0.1772-0.1776”
Valve Guide/Stem Clearance (Intake) 0.0004-0.0015”
Valve Guide/Stem Clearance (Exhaust) 0.0010-0.0020”
Valve Face Width (Intake) 0.0315-0.0472”
Valve Face Width (Exhaust) 0.0197-0.0354”
ITEM
Component Test Value + Test Connections -
5000/9000 (Normally Closed Ignition)
Magneto Coil (3 tests) 0.2-0.4 ohm yellow yellow
Ignition Coil (1) 1.4 ohms red/green gray/green
Ignition Coil (2) 1.4 ohms red/green brown/green
Fuel Injector 9-12 ohms (5000)
10.5-13 ohms (9000) lead
lead lead
lead
Crankshaft Position Sensor 173-211 ohms blue/white green/white
Injection Coil 3.6 ohms black/yellow black
Voltage Regulator/Rectifier* 12-14.5 DC Volts terminal terminal
Magneto Coil (no load)
(3 tests) 36-44 AC Volts yellow yellow
Spark Plug Cap 4000-6000 ohms cap end cap end
Ignition Switch Less than 1 ohm
(key in ON position) terminal terminal
7000 (Normally Closed Ignition)
Magneto Coil (3 tests) 0.15-0.23 ohm white white
Ignition Coil (1) 1.19-1.61 ohm orange gray/red
Ignition Coil (2) 1.19-1.61 ohm orange brown/pink
Ignition Coil (3) 1.19-1.61 ohm orange gray/brown
Fuel Injector 86.4-105.6 ohms lead lead
Crankshaft Position Sensor 336-504 ohms gray black
Injection Coil (1) 86.4-105.6 ohms red/blue red/black
Injection Coil (2) 86.4-105.6 ohms red/blue green/black
Injection Coil (3) 86.4-105.6 ohms red/blue blue/black
Voltage Regulator/Rectifier* 12-14.5 DC Volts terminal terminal
Magneto Coil (no load)
(3 tests) 40 AC Volts at idle white white
Ignition Switch Less than 1 ohm
(key in ON position) terminal terminal
Spark Plug Cap 5.8-11.5 ohm cap end cap end
! WARNING
Most voltages generated by the ignition system are suf-
ficient to interrupt pacemakers! All technicians, espe-
cially those using pacemakers, must avoid contact with
all electrical connections.