Arctic Cat 2008 400 4x4, Operator'S Manual

Page: 51 / 82

Page 49
Preparation for storage
!! CAUTION !!
Prior to storing the ATV, it must be
properly serviced to prevent rusting
and component deterioration.
Arctic Cat recommends the follo-
wing procedure to prepare the ATV
for storage. An authorized Arctic
Cat ATV dealer should perform
this service; however the owner/
operator may perform this service
if desired:
1. Clean the seat cushion with a
damp cloth.
2. Clean the ATV thoroughly by
washing dirt, oil, grass and other
foreign matter from the entire ATV.
DO NOT get water into any part of
the engine or air intake. Allow the
ATV to dry thoroughly.
3. Either drain the gas tank or add
a fuel stabilizer to the gas in the gas
tank. Remove the air fi lter. Start
the engine and allow it to idle.
Then using Arctic Cat Engine Pre-
server, rapidly inject the preserver
into the air fi lter opening for a peri-
od of 10 to 20 seconds. Install the
air fi lter.
!! CAUTION !!
If the interior of the air fi lter housing
is dirty, clean the area before star-
ting the engine.
4. Drain the carburettor fl oat bowl.
5. Plug the hole in the exhaust sys-
tem with a clean cloth.
6. Apply light oil to the upper stee-
ring post bushing and plungers of
the shock absorbers.
7. Take care that all screws, nuts
and holding components are tighte-
ned properly.
8. Clean the ATV thoroughly.
9. Disconnect the battery cables
(negative cable fi rst); then remove
the battery, clean the battery posts
and cables and store in a clean
dry area.
10. If possible, store the ATV in-
doors.
!! CAUTION !!
Avoid storing outside in direct sun-
light and avoid using a plastic cover
as moisture will collect on the ATV
causing rusting.