Instruction manual –AQ F210 Feeder Protection IED
242 (292
)
Data points list can be read from the device.
IEC 103 parameters can be found in the following table.
Parameter
Range
Description
Slave address
[1…254]
IEC 103 slave address for
the unit.
Measurement interval
[0…60000]ms
Interval setting for the
measurements update.
5.1.7
DNP3
DNP3 is a protocol standard which is controlled by the DNP Users Group at
The implementation in the AQ2xx series of a DNP3 slave is compliant with DNP3 Subset
Definition Level 2, but contains also functionality of higher levels. For detailed information
see the DNP3 Device Profile document.
DNP3 parameters can be found in following table.
Parameter
Range
Description
Slave address
[1…65519]
DNP3 slave address for
the unit.
Master address
[1…65519]
DNP3 address setting for
allowed master.
Link layer timeout
[0…60000]ms
Timeout of link layer
Link layer retries
[1…20]
Number of link layer
retries
Application layer timeout
[0…60000]ms
Application layer timeout
Application
layer
confirmation
[0=No,1=Yes]
Application
layer
confirmation enable.
Time
sync
request
interval
[0…60000]ms
Request
interval
for
synchronization.
5.1.8
IEC
101
/
104
Standards IEC 60870-5-101 & IEC 60870-5-104 are closely related. Both are derived from
IEC 60870-5 standard. On the physical layer IEC 101 uses serial communication but IEC
104 uses Ethernet communication.
The IEC 101/104 implementation in AQ2xx series works as a slave in unbalanced mode.
