Architect 1600 SE, Professional Installer'S Consciousness Manual

Page: 17 / 36

Architect
Model 1600 SE
Model 1601 SE
installer’s Guide
™
SPEakEr Hook-UP
The same rule applies to the speaker wires as the RCA con-
nections. Establish a standard connection color code and stick
with it. One conductor of the speaker wire is normally marked
by a different color (silver versus copper) or there is a ribbing on
one side. Typically this marked conductor is used for the positive
(+) speaker leads. Of course the really good wire has Positive and
Negative printed right onto the wire jacket.
Your choice of speaker wire gauge and the length of the runs
also affects the speaker impedance load presented to the ampli-
fiers. As you can see in this table, even fairly short speaker runs
can have significant resistance if you use a smaller wire gauge.
This can be a benefit if you are paralleling lots of speakers. The
wire itself acts as an impedance limiter, since the amplifier can -
not see a speaker load lower than the resistance of the wire. The
downside of this resistance in the wire is that you waste some part
of the total power available to the speakers.
See the appendix for information about bridging the Architect
into mono operation.
Congratulations! You’re done with the audio hook up. Now
for the details of operation…
Speaker connection wiring
installation:
the Long Version
25’ 50’ 100’ 250’ 500’
24 GA 1.3 Ω 2.6 Ω 5.1 Ω 12.8 Ω 25.7 Ω
22 GA 0.8 Ω 1.6 Ω 3.24 Ω 8.1 Ω 16.0 Ω
20 GA 0.5 Ω 1.0 Ω 2.0 Ω 5.0 Ω 10.1 Ω
18 GA 0.3 Ω 0.6 Ω 1.28 Ω 3.2 Ω 6.4 Ω
16 GA 0.2 Ω .4 Ω 0.8 Ω 2.0 Ω 4.0 Ω
14 GA 0.1 Ω .25 Ω 0.5 Ω 1.26 Ω 2.5 Ω
12 GA 0.08 Ω .16 Ω 0.32 Ω 0.8 Ω 1.6 Ω
13
Speaker Wire Resistance Wire Gauge versus Run Length