arcelik BEKO RETRO, Service Manual

Page: 39 / 98

RETRO WASHING MACHINE
39
7.3. Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild gel
detergents as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
7.4. Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also
at the end of each water intake hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the washing machine. Filters
should be cleaned as they do get dirty.
1. Close the taps.
2.
Remove the nuts of the water intake hoses to access the filters on the water intake valves.
Clean them with an appropriate brush. If the filters are too dirty, take them out by means
of pliers and clean them.
3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and
clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.
7.5. Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of washing water. Thus, the water will be discharged
without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of
freezing of the water, water may have to be drained completely.
Figure 7.4