10 /30 EN
Refrigerator / User manual
3
Installation
Always have the installation and repairing
procedures carried out by the Authorized Service
Agent. Manufacturer shall not be held liable for
damages that may arise from procedures carried
out by unauthorized persons.
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
Authorized Service Agent. If not, call a qualified
electrician to have any necessary arrangements
carried out.
C
Preparation of the location and electrical
installation at the place of installation is
under customer's responsibility.
B
Product must not be plugged in during
installation. Otherwise, there is the risk
of death or serious injury!
B
WARNING:
Installation and electrical
connections of the product must be
carried out by the Authorised Service
Agent. Manufacturer shall not be held
liable for damages that may arise from
procedures carried out by unauthorised
persons.
A
WARNING:
Prior to installation, visually
check if the product has any defects
on it. If so, do not have it installed.
Damaged products cause risks for your
safety.
C
Make sure that the power cable is not
pinched or crushed while pushing the
product into its place after installation or
cleaning procedures.
3.1. Appropriate installation location
A
WARNING:
If the door of the room where
the product will be placed is too small for
the product to pass, then the product's
doors must be removed and the product
must be turned aside to pass it through.
t$IPPTFBQMBDFBUXIFSFZPVXPVMEVTFUIF
product comfortably.
t*OTUBMMUIFQSPEVDUBUMFBTUDNBXBZGSPN
heat sources such as hobs, ovens, heater
cores and stoves and at least 5 cm away from
electrical ovens. Product must not be subjected
to direct sun light and kept in humid places after
installation.
t:PVSQSPEVDUSFRVJSFTBEFRVBUFBJSDJSDVMBUJPOUP
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
t*GUIFQSPEVDUXJMMCFQMBDFEJOBOBMDPWF
remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls. Check if the rear wall clearance
protection component is present at its location (if
provided with the product). If the component is
not available, or if it is lost or fallen, position the
product so that at least 5 cm clearance shall be
left between the rear surface of the product and
the wall of the room. The clearance at the rear is
important for efficient operation of the product.
t%POPUQMBDFUIFQSPEVDUPOUIFNBUFSJBMTTVDIBT
rugs or carpets.
t1MBDFUIFQSPEVDUPOBOFWFOGMPPSTVSGBDFUP
prevent jolts.
C
If two coolers are to be installed side
by side, there should be at least 8 cm
distance between them. Otherwise,
adjacent side walls may get damp.
3.2. Installing the plastic wedges
Plastic wedges are used to create the distance for
the air circulation between the product and the
rear wall. Insert the 2 plastic wedges onto the rear
ventilation cover as illustrated in the figure. To install
the wedges, remove the screws on the product and
use the screws given in the same pouch with the
wedges.
