56
CNC System Instruction
Appendix I: Instructions for Software Upgrading Operation of
SH
-
2012AH
Functions:
The system software is allowed to upgrade through an USB disk.
The specific operation procedure is as follows:
1.File upgrading
Copy the upgrading file titled STARTCNC.EXE to an USB disk.
2.Operation procedure
Push and hold the button between the red button 0 and the USB port.
Power the system on and release the button when upgrading window appears on the display screen. Plug the USB disk
into the port and press Key F1 under the display screen(the key corresponds to "
UPGRADE
" in the menu displayed).
The system will automatically start upgrading operation.
3.Upgrading end
If program upgrading is successful, the system will prompt "Upgraded Successfully" and sound one beep. If program
upgrading fails, the system will prompt "Upgrade Failure" and sound continuous beeps.
。
4.New program startup
Power the system off and unplug the USB disk. Reboot the system to start up the upgraded program. The version num-
ber of the upgraded program will appear on the screen after booted up.
Notes:
Please make the following check if upgrading operation fails.
1) The USB disk must be
FAT or FAT32 format
. FAT format is preferable.
2) The upgrading file must be titled as
STARTCNC.EXE
.
3) If no prompt appears in the upgrading process and the display returns to the main upgrading window or upgrading opera-
tion fails due to any other interruption, verify first the name of upgrading file and the format of USB disk. If these two factors
are assured, try to upgraded the program again following the specific operation procedure.
