Arcam DV89, Handbook

Page: 12 / 24

DV89
12
DV89
13
Using the remote control
OK
ANGLE
CD DVD
SETUP STATUS SRCH
ZOOM AUDIO MEM RTN
P
MODE
SUBT TITLE MENU
RPT CLEAR
0
PROG
A-B
7
8
9
DISP
4 5 6
CD
DVD
1 2 3
MUTE
OPEN
CD/DVD REMOTE
CR-314
CD/DVD
Ensure that DVD mode is selected using the
CD/DVD
toggle button. The ‘DVD’ LED above the
CD/DVD
button
is lit briefly when DVD mode is selected.
DISP (display)
Dims or turns the DV89’s display on or off. Turning the display off
generally gives a slight improvement in sound quality.
Pressing
DISP
once turns the display off; twice dims the display.
To restore the display to full brightness, press
DISP
a third time.
A–B
This button enables you to repeat a selected
section from the disc (see page 14).
RPT (repeat)
Press RPT to cycle through the repeat play options.
CLEAR
Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear
a numeric field (see pages 14–15).
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
select a track, press the corresponding keypad button followed
by
OK . For tracks greater than 9, enter the digits in sequence.
For example, to play track 15, press 1 , then 5 , then OK .
PROG (program)
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
PROG to access the
’Programme’ menu (see pages 15 and 17).
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (
+ / – ) controls and
MUTE
button have
no effect on the audio output level of the DVD players.
NOTE
: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
OPEN
Opens and closes the disc tray.
Page Up/Down (DVD-audio)/Slow play (other discs)
DVD-audio
: Some DVD-audio discs allow the user to
browse through images (photographs of the artist, lyrics,
etc.) while music is being played. Use the or buttons
to change to the previous/next page. Note that this is not
availble on all DVD-audio discs.
Other discs : Press or on the remote control to play
slow forward or backwards. There are four speeds of
slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button
repeatedly to cycle through the different speeds. To resume
normal playback speed, press
PLAY
.
NOTE : Slow play does not apply to audio CDs or DVD-audio
discs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confirm your selection with the OK button.
Playback control
Pause ( ), Play ( ) and Stop ( ) (see page 11).
Fast play and Skip chapter/tracks
Play fast ( ) and Skip ( ) chapters/tracks in both
directions (see page 11).
Advanced controls
These buttons are described on the facing page.
Standby
Press Standby to toggle the standby state of the DVD player.
Note that Arcam CD players are not controlled by this button.