11-36
SET-UP AND SAFE OPERATING PROCEDURES
89210000
CLIMBER TRACTOR AND MAGNET INSTALLATION
Attach magnet assemblies to the track. For out-of-position work, the magnets should be
spaced 12 inches apart. For flat work, the spacing can be extended to 24 inches. Remove
the magnet keepers. Be sure the magnets and the work surface are free of foreign materials.
Put the track where you want it. Before fastening the magnets to the workpiece, put the lever
on the magnets in the vertical position to achieve full contact between the magnet and work
surfaces.
CAUTION
Attach safety clamps to the track when working out of position. (Not supplied
by Tweco-Arcair)
MOUNT TRACTOR TO TRACK
Lift the drive-gear lever to the disengage position to raise the motor and gear for freewheeling.
Slide the tractor onto the end of the track. Freewheel the tractor to the position you want it
and lower the drive-gear lever to engage the motor and gear to the rack (Fine adjustment for
track width may be necessary).
FINE ADJUSTMENT FOR TRACK WIDTH
Make fine adjustments by loosening the lock nuts on the two adjustable wheel legs. Rotate the
flat head screw for a snug fit on the track. Hold the flat head screw to prevent turning. Tighten
the lock nuts.
HORIZONTAL RACK ASSEMBLY
To attach the Horizontal Rack Assembly (if used) to the base of the Climber Tractor, do these
things:
1. Move the Rack Bar so its holes align with the screws in the mounting plate.
2. Line up the screws with either of the two sets of holes in the tractor base.
3. Insert a screwdriver through the holes in the Rack Bar and tighten the screws to the
base of the tractor.
VERTICAL ADJUSTMENT ASSEMBLY
Mount the Vertical-Adjustment Assembly (if used) to either side of the Rack-Bar Assembly and
secure with the two hex - head machine screws provided.
CLIMBER TRACTOR MAINTENANCE
GENERAL MAINTENANCE
ArcairClimber V_A Travel System
