Flex 2JB-VRX Instruction Manual
June 2022 v1.0
Page 36 of 70
4.2.5 Function Relay Outputs
Listed below are other types of functions that can be outputted through the three Function output
relays (K25, K26 and K30). Refer to section 4.2.6.6 ~ 4.2.6.8 function relay programming.
LV
:
Function relay closes when receiver voltage is low.
ID
:
Function relay works simultaneously with all motion commands.
NORMAL :
START fu AUX with normal momentary output. Works the 2
nd
time
the START button is pressed.
NORMAL2 :
START fu AUX with normal momentary output. Works the 1
st
time
the START button is pressed.
TOGGLE :
START fu AUX with toggled output.
TOG&E :
START fu AUX with toggled output. The relay opens when STOP
button is pressed down.
EXT
:
Function relay works simultaneously with the receiver MAIN relays.
TDM A+B :
Function relay closes when selector switch is rotated to the A+B position
and opens when rotate to A or B positions (tandem monitoring output).
HORN
:
Function relay closes for up to 3 seconds when START button is pressed
at transmitter power on and then becomes a normal momentary output
thereafter.
G SENSOR :
Function relay closes when Zero-G sensor is triggered (receiver MAIN
relays deactivated) and opens when receiver MAIN relays are reactivated.
RESET
:
Function relay closes when the START button is pressed and opens when
let go. Works during initial transmitter startup and inactivity timer START
reset.
SW1 ABC
:
Function relay closes at C position (for button or toggle switch programmed
to Select A/B/C function).
SW2 ABC
:
Function relay closes at C position (for button or toggle switch programmed
to Select A/B/C function).
SW3 ABC
:
Function relay closes at C position (for button or toggle switch programmed
to Select A/B/C function).
SW4 ABC
:
Function relay closes at C position (for button or toggle switch programmed
to Select A/B/C function).
SW7 ABC
:
Function relay closes at C position (for button or toggle switch programmed
to Select A/B/C function).
