ARC A015, User Manual

Page: 10 / 16

DIMENSIONS FOR OVEN AND INSTALLATION
5 7 5 mm
5 9 5 mm
5 9 5mm
560 mm
5 7 0 mm
min.
560 mm
600mm
600 mm
INSTALLATION NOTES:
• If fitted with plug and lead the location of the power point cannot be mounted directly behind t he
t he oven as this will impe de the oven sitting correctly into the cabinet.
• When mounted under bench and there is a bench above the oven, air flow ven t ilation is
important to help keep the cabinets and oven el e ctronics from getting to hot. P lease note three
ways that this can be achieved and illustrated above with the matching letters.
o
A - Th is represents the cabinet rear panel being removed . W ith the panel removed , it can
draw some air from under the base panel and behind the adjacent c abinets
o
B - -
This represents the use of plinth supports at the bottom on either side in lieu of the
cabinet base panel to support the oven in place and improve s the air flow.
o
C- I I f base panel is in place it is recommended to cut an opening under the oven to draw
air through and around the oven. M inimum si z e cutout should measure 400 mm x 400 mm.
O ne of these methods MUST BE i ncorporated otherwise warranty may be voided .
A
C
B
COOLING FAN
O ven vent holes
• To improve the efficiency of keeping the cabinet and oven electronics from getting to hot,
the oven is fitted with a cooling fan located in top of the oven. Ambient air from outside the
oven is drawn in by means of this cooling fan and the hot air is expelled from a series of
vent holes located at the top of the oven cavity just above the door.
NOTE: Even after the oven has been turned off the cooling fan will continue to run for a period
of time to keep doing it's job. There is no need to be concerned as this normal and uses very
little energy.
9