4 Installing the Air System
26
4.1.2
Connection to an Alternate Air Source
For ease of installation, quality of air supply, and a high level of
dependability from your
Air Locker
(s), ARB strongly recommends use of
a genuine
ARB Air Compressor
, however, the
Air Locker
air system can
be operated on any alternate air source that meets each of the following
guidelines:
Must supply a minimum of 85PSI [586kPa].
The air source should have a tank capacity which enables it to
actuate the
Air Locker
(s) in one charge so that no hesitation is
experienced when locking one or two differentials.
HINT : A good way to insure that you have the necessary
capacity is to make sure you can engage, disengage, and
then reengage your Air Locker(s) without the air source
having to regenerate (e.g., without the compressor
turning on to refill the tank).
Must supply clean air, free of rust, dirt, water, or other foreign
matter.
Must match the 1/8” BSP porting of the
Air Locker
solenoid.
Mount solenoid within close proximity of the air supply and secure it
from the effects of vibration and shock.
Connect the air supply to the 1/8” BSP inlet port of the solenoid
(stamped “1” on the solenoid body) using thread sealant.
IMPORTANT :
ARB cannot warranty your Air Locker(s) against damage
caused as a result of using an alternate air supply. If you
have any doubts as to the suitability of your air system to use
in an Air Locker system, consult your ARB distributor.
Summary of Contents for Air Locker RD111
Page 1: ...RD111 TOYOTA 8 IFS 53MM CARRIER BEARING AIR OPERATED LOCKING DIFFERENTIAL INSTALLATION GUIDE ...
Page 4: ...2 ...
Page 39: ...6 Testing Final Assembly 37 ...
Page 40: ......
