ARANA FRESCO30, Installation And Operating Instructions Manual

Page: 60 / 76

EN
60
Gently push down the sliding lid out of the guide slot and remove it.
Insert the new batteries (2*type AAA) in the remote control as indicated in the battery
compartment.
Push the sliding lid into the guide slot, and push up to close it.
The battery compartment is located below the sliding lid of the remote control.
6.2 Checking remote control and insert batteries
Check whether the supply voltage corresponds to the values specified in the data
plate .
Ensure both the air intake opening and the air nozzles are free. All ventilation grilles
must always be kept free to ensure that the rooftop air conditioner is able to operate
at maximum capacity.
Before you switch on the rooftop air conditioner, observe the following:
6.0 Initial use
6.1 Inspection before starting up
Do not insert your fingers or objects into the air nozzles or the intake grille.
Beware of injury!
ATTENTION!
All the wirings must be connected by qualified electrician and comply with the
national and local wiring codes and/or regulations.
The rooftop air conditioner must connect to the circuit which is able to supply
the needed current.
Select the cross sections of the wirings which are correspond to the following
lengths:
Length < 7.5m; 2.5mm² (national standard)
Length > 7.5m; 4mm² (national standard)
Lay cable duct between the gap of vehicle to connect the power wirings.