ARAG 853 3 44 Series, Installation, Use And Maintenance Manual

Page: 15 / 50

15
GB
5.6 Wiring connections
To connect the valve, use the cable with Tyco Superseal® 4-pole connector for CAN-BUS.
1 2 3 4
1 GND
2 +12 Vdc
3 CAN L
4 CAN H
Fig. IX
Connect the valve connector to that of the relevant harness; make sure it is correctly fitted and push
it until it locks in place (
Fig. VII ).
WARNING: CHECK THAT THE CONNECTOR IS FITTED CORRECTLY TO ENSURE A
PROPER SEALING.
WARNING: If the gasket is not positioned correctly, there may be infiltrations of water
in the connector and in the valve, with the consequent risk of damage to the device.
6 USE
6.1 Commands
The specifications of SAEJ1939 and A-Net protocols to send commands to the valve can be
requested by contacting the ARAG technical support department to the following address: support@
aragnet.com.
6.2 LED signals
A LED positioned on valve connector indicates the relevant status:
GREEN BLINKING
An intermittent flashing lasting 10 seconds indicates that the valve is
waiting to acquire a CAN-BUS address.
After the aforementioned
period, the LED turns solid green, even if the address has not yet
been acquired
.
GREEN STEADY
ON
The valve is configured and functioning.
RED
BLINKING
A red flashing indicates a malfunction.
An error code is identified according to the number of blinks
(refer to
Tab. 4
)