Arada Farringdon 8, Operating & Installation Manual

Page: 11 / 28

Page 11 Arada Farringdon
INSTALLATION
Back side liners
Fig 3
Fig 4
Side air ducts
Front side
liner
1 per side
Rear liners 2 off
Throat plate sat correctly
on air tube and rear air bar
FIREBOX LINER PANELS
The Arada Farringdon stoves use firebox liner
panels to the sides and back. The throat plate sits
on top of the perforated air tube at the front and
into two slots in the rear air bar. These parts
should come fitted to your stove, if however they
are not, proceed as follows to fit them.

Open the fire door.

Remove the fuel retaining bar, by lifting free
of the retaining slots.

Set the rear liner (s) into the back of the
firebox.

Remove the throat plate insulation from its
packaging and place on top of the throat
plate and lift into position with the front
above the perforated air tube. Align the 2
tabs on the throat plate with the location
slots in the rear air bar and drop into posi-
tion (See Fig 5)

Insert one of the side liner panels in each
side at the back sitting on the side landing.
Lift up one at a time past the throat plate
as far as it will go and slide in the lower liner
side liner.
Repeat for the other set of rear side liners.
(See Fig 3&4)

Insert one front side liner in each side
of the front of the stove. Secure in place with
the front liner clamp as shown.
(See Fig 3&4)
Note: Neither the rear firebox liners nor the
side firebox liners are ‘handed’, both faces are
suitable for direct contact with the fire bed.
Front liner securing clamp
Fig 5: Overhead view of Liners and Throat
Plate assembly
Throat plate
location tab
and slot in
rear air bar