10
Super Shuffle Operating Manual
2. Go to Setup Menu.
3. Select Diagnostics.
4. Select Hardware test.
5. Select Laser/Sensor Test.
This displays an image of the lasergrid.
The percentages represent the strength of the lasers.
3. Insert the same allen wrench you used in step 1 into the
hole provided on the laser adjustment ball.
4. Adjust the lasers. Use the Laser/Sensor Test screen to
help you align the lasers. The closer to 100% the better
the alignment is. A rating of 100% is dead on.
Laser
Adjustment
Ball
Good Alignment
Poor Alignment
5. Once adjusted, close the laser access plate and screw it
down.
CAUTION: Do Not Over Tighten The Laser Brackets.
7.2 Replacing the Laser Sockets
The Laser Mount Sockets are what hold the laser “eye”
in the Super Shuffle.
1. Unplug the Super Shuffle from the wall.
2. Unscrew the top screw to the laser cover plate.
3. Unplug the green ground wire and the laser cable.
4. Using a 5/16 nut driver, remove the three nuts holding
the laser sockets together.
5. Unscrew the ground tab.
Ground Cable
Ground Tab
Laser Cable
Laser
Ball
Laser
Socket
You will need a 1/8” Allen Wrench for this task.
1. Remove the top allen
screw and let the laser
access plate hang loose.
Section 7
Maintenance
There will be times when you will need to manipulate the hard-
ware on the Super Shuffle. This section will explain how.
7.1 Adjusting the Lasers
T
he lasers are what the Super Shuffle uses to sense when
a puck has scored. From time to time, these may be
knocked out alignment. Follow the instructions below:
Laser
Sensor
6. Remove the first half of the bracket by pulling it
toward you. The laser will come out with it. Take note
of how the bracket came out, you will have to put the
new one in the same way.
Laser
Socket
Laser
Ball
