Arachnid galaxy 3, Operator'S Manual

Page: 8 / 36

Galaxy 3 Operating Manual 3
3.3 Standby Switch and Reset Button
This section describes the functions of the Standby
switch.
1. Standby Switch - This switch controls Monitor and
Target Illumination Panels. Toggle this switch to put the
Galaxy 3 in standby mode. This will leave the main
board on but everything else will be turned off.
2. Reset Button - Restores power to the game if AC power
is lost.
3.4 Power Inlet and Fuse
1. Power Inlet - Is where the power plugs in to the
machine.
2. Fuse - Is a 3.5A Slo-Blo.
3.4 Mother Board Ports
This section describes the functions of the various ports on
the back of the game as well as the function for the Stand-
by switch.
Caution: The Target Camera, Play Camera, Left LED,
Right LED and the Marquee will not function if they are
not plugged into the correct ports. (See Mother Board
Color Code Diagram on page 7.)
1. This is the VGA port that your monitor is plugged into.
2. The IOB is plugged into this port and controls various
functions like the navigation buttons and coin switches.
3.5 IOB Basics
This section describes the basic layout of the IOB. The
IOB or Input/Output board controls the various external
devices in the dartboard such as the Target Interface Board,
the target LED’s and the Marquee.
1. Plug for the Coin Door Wire Harness
2. Plug for the Main Wire Harness.
1
2
3
4
5
6
7 8
9
1
2
12
11
10
1
2
3
13
9
6
8
7
10
2
4
11
5
14
15
17
16
18
1
12
3. Controls camera pointed towards the player.
4. Used to set up a wired network with a router. It is
already plugged into its counterpart on the back of the
machine.
5. This port is used to update machine information,
leagues, and software.
6. Controls camera pointed towards the target.
8. Use this PCI slot to plug in a modem or a WiFi card.
7. Controls the speakers.
9. Controls the Marquee on the top of the machine.
10.Controls the left Target Illumination Panel.
11.Controls the right Target Illumination Panel.
12.This port controls the Target Interface Board. All sig-
nals coming from the darthead flow into this port.
3. Plug for the Left Target Illumination Panel.
4. Plug for the Marquee on the top of the machine
5. Plug for the Right Target Illumination Panel.