AquaVac King Shark, Owner'S Manual

Page: 7 / 19

- 8 -
KingShark
3. Upon completion of vacuuming the pool, allow the unit to travel to the
shallow end of the pool. Before it reaches the pool wall, turn power
supply off, raise the unit by the cord, then remove the unit from the
water by use of the handle. Allow excess water from the filter to drain
into the pool with the KingShark resting on the edge or coping. Do
not leave machine in water after turning off.
4. When opening the filter for cleaning, move the machine away from the
pool edge so that when filter casing is opened the vacuumed debris
will not return to the pool.
5. Cleaning the filter after each use is the most important part of
maintaining your KingShark. Clean filters will allow the machine to
function most efficiently.
6. Remove the fi lter by fi rst removing the two push clips as seen
below.
Following the removal of the push clips, gently grasp the rear fi lter
plate with the thumbs pressed fi rmly against the tie rod ends and
remove rear plate.
7. Wash the cartridge with a water hose, using a pressure nozzle. Wash
outside—then back wash from the inside.
8. Use the KingShark on a regular basis to keep your pool clean.
MOTOR INFORMATION
The motor in your KingShark has automatic overload protection. The overload
switch will protect the motor against burning out when an obstruction stops the
machine. When an obstruction stops the machine, UNPLUG THE CORD FROM
THE OUTLET and remove the unit from the pool. Turn the machine over and with
the aid of a long screw driver or needle-nose pliers, rotate the impeller and dislodge
any foreign object. All large objects should be removed from the pool before the
KingShark is put into operation.