Aquatronica ACQ210N-MS, Instruction Manual

Page: 6 / 16

IsACQ210NMSC-0 (ENG) Rev.250708-0 6 - 16
Via dell’Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: service@aquatronica.com
(Fig. 6)
Programs
Ref. 900mS
∆ MIN: ∆ MAX:
100 µS 200 µS
Sockets Confirm
(Fig. 5)
Conductivity
Insert
English
Programs
This option is used to create programs based on the
Conductivity value.
To set up a program, the following must be estab -
lished:
- A reference value , defined as the Conductivity for the
tank, which the system will aim to maintain.
- A ∆ Max value , defined as the tolerance that must
be observed with respect to values higher than the
reference value.
For example: If the reference is set to 900mS and the
∆ Max is 200mS, the system will be enabled at values
higher than 1100mS (see chart).
- A ∆ Min value , defined as the tolerance that must
be observed with respect to values lower than the
reference value.
For example: If the reference is set to 900mS and the
∆ Min is 100mS, the system will be enabled at values
lower than 800mS (see chart).
To insert a program, proceed as follows:
Main screen

Main Menu

Conductivity

Programs.
• Select “ Insert ” using the

keys and press “ En-
ter ” (Fig. 5).
Insert
In this screen, the conductivity value to obtain can be
chosen and a minimum and maximum tolerance can
be set (Ex. Fig. 6).
To set this program, proceed as follows:
Main screen

Main menu

Conductivity

Programs

Insert.
• Select with the reference conductivity value using
the

keys and set the desired value using the

keys.
• Set the “ ∆ MIN” and “ ∆ MAX” tolerances; select the
desired parameter using the

keys and modify the
value using the

keys.
• Select “Sockets” using the

keys to choose
how the outputs will function when the conductivity
level goes above or below the set values. Then press
“Enter”.
• Select the output to be controlled using the

keys.
The selected output will blink on both lines.
The outputs on the upper line determine which devices
must be enabled/disabled when the conductivity goes
above the set maximum value (Ref. + ∆MAX); the out -
puts on the upper line are set using the

key.
900
800
1100
Conductivity
Tempo
Ref.+
∆
Max
Key to symbols
Values for which the system is enabled
∆
Max=200mS
∆
Min=100mS
Ref.
Ref.-
∆
Min