IsACQ210NMSC-0 (ENG) Rev. 250708-0
11 -16
Via dell’Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: [email protected]
About
Provides information on the control unit’s firmware
version.
To use this function, proceed as follows:
Main screen
Main menu
Conductivity
About.
Disconnect
If the conductivity interface is disconnected, a message
will appear on the display (Fig. 18). Press
“Enter
” to
indicate that the message has been read.
On the main screen the
“?”
icon will appear next to the
name of the
“Conductivity”
sensor and in the lower
left corner (Fig. 19).
If the conductivity interface is reconnected, the con
-
trol unit will automatically begin displaying the read
value again.
To definitively eliminate the conductivity sensor from the
system, after disconnecting it, proceed as follows:
Main screen
Main menu
Conductivity
Disconnect.
The
“Data Record”
and
“Calibrate Sensor”
functions
disappear from the
“Conductivity”
menu (Fig. 20) and
the
“Disconnect”
function appears.
•
Select this function using the
keys and press
“Enter”
.
•
The disconnection screen will appear (Fig. 21). Press
“Enter”
to disconnect or
“Esc”
to cancel.
English
(Fig. 18)
Device
Disconnected
S01: Conductivity
(Fig. 19)
Mon 11/06/07 15:05
PU01 A B C D E F G H
Conductivity ?
(Fig. 20)
Conductivity
Change Name
Programs
Alarm
Disconnect
(Fig. 21)
Disconnect
Conductivity
Enter: Confirm
Esc: Cancel
(Fig. 17)
Aquatronica
FW version: x.y
Press any key to
continue