5
dual-laMP t5 ho
inStallation
The Aquatic Life Marine Light Fixture is shipped with the T5HO fluorescent lamps already in place; however, the shipping materials will need
to be removed prior to operation. place the light fixture on a surface that will not mar or scratch the fixture.
Tools required for installation:
Philips #2 Screwdriver
2) After the four screws are removed,
pull the End plate from the fixture.
3) Slide the Acrylic Lens Cover out of the fixture.
4) Acrylic scratches easily and your new
fixture includes a plastic film on the Lens
Cover to protect it during shipping. peel
the protective film off both sides of the
Acrylic Lens Cover.
PaCkaging
NOTE:
DO NOT replace the End plate
until the Aquarium Frame Mounts have
been attached.
NOTE:
The lamps will be packaged under
the Lens Cover, do not discard.
TIp:
Use a large towel under the fixture
while removing the shipping materials to
avoid scratching the fixture.
A
B
C
1) Remove the four screws from the right
End plate (non power cord side) of the
fixture (philips Screwdriver required).
Page 8
Page 7
Page 9
The lamps are packaged in a protective plastic to help eliminate damage during shipping. The lamps also have a protective foam to eliminate
damage from shipping.
LamPs
1) Remove the protective foam from the lamps.
2) Remove the protective plastic cover from around the lamps.
3) T5HO lamps use a mini bi-pin connection to make contact with the fixtures sockets.
The lamps require that both ends of the lamps be inserted vertically into the sockets
and twisted either front to back or back to front. The mini bi-pin connections will now
be horizontal in the socket.
D
