Camera Installation
11 |
A R 5 I N S T R U C T I O N M A N UA L
STEP 3:
Mount your strobes and their arms onto the housing. For details about optical
flash triggering and wired bulkheads, refer to the
section (page 28). Follow your strobe manufacturer manual and its
recommendations.
STEP 4:
Before use, remove the main O-ring seal from its groove on the front half of the
housing and carefully verify that the O-ring and its groove are free from scratches
or foreign matter. Lubricate the O-ring with a light coat of silicone grease.
WARNING:
For proper handling of O-rings, follow the detailed instructions outlined in the
section (page 33).
STEP 5:
Insert the provided CR 2450 coin cell battery in the Surveyor alarm (rear half of
housing) as described in the
section (page 22).
Camera Installation
Follow these steps to prepare your Canon EOS R5 camera for use with your housing. It is also
advisable before inserting the camera into the housing, in order to save valuable time
underwater, to set your camera shooting preferences beforehand.
STEP 1:
Remove the saddle from the housing by pressing the saddle locking tab and
pulling the saddle out of the housing.
STEP 2:
Install the camera on the saddle by aligning the positioning hole under the
camera and screwing the bottom screw with either a flat screwdriver or a coin.
