AquaScape 83013, Instruction Manual, Page: 12 / 48

• Loosen the collar in the
center of the rotational ball
and rotate until the inlet and
outlet form a 90
º angle
(Figure 18).
• Attach the rotational ball
to the outlet of the pump
with the included flat rubber
washer (Figure 18).
• Next, locate the AquaBasin
®
Plumbing Adapter and thread
it into the bulkhead from the inside of the basin, hand-
tighten until secure (Figure 19).
• Place the pump into the basin and
attach the threaded collar of the
AquaBasin
®
Plumbing Adapter to
the rotational ball output with the
flat rubber washer (Figure 20).
Note: Replace the pump
access panel at this time
to prevent dirt and debris
from making its way into the
basin during the remainder
of the installation.
Figure 18
Figure 19
Figure 20
STEP 8
PUMP PREPARATION AND INSTALLATION
• Remove the included AquaSurge
®
2000 Pond Pump from its
packaging. Then, remove the outer
filter screen that covers the intake
of the pump (Figure 15). The outer
filter screen is designed to pop off
when it is pulled from either side.
• Next, remove the inner filter screen
by twisting it in a counterclockwise
motion, unscrewing it from the
intake (Figure 16).
• Thread the included AquaSurge
®
Low Suction Intake Attachment
with the included flat rubber
washer hand-tight onto the intake
of the pump with the filter screen
sitting parallel to the ground
(Figure 17). This attachment will
maximize the amount of usable
water in the basin.
Figure 15
Figure 16
Figure 17
12
aquascapeinc.com
86319 - 83013 Backyard Waterfall LFK [Instructions] 1-18.indd 12 1/23/2018 3:33:36 PM