4 — INSTALL RO FAUCET
You will need a sink top hole 1" in diameter. If drilling a new hole, ensure faucet body will
mount flat against surface and that there is sufficient tubing between faucet body and system
manifold. NOTE: Drilling holes into solid surfaces or surfaces made of stone should only be
performed by a qualified and certified installer.
1
Place the black rubber gasket into the groove of the faucet base and feed the tubing and
faucet threads through the countertop hole.
2
Underneath counter, slide on the slotted washer, spacer and nut. Tighten with wrench.
3
Tighten the white quick connector onto the base of the faucet threads.
4
Attach 3/8" white tubing by inserting into quick connector approximately 5/8" until it stops.
Gently tug on the tubing to ensure it is firmly seated in fitting.
NOTE: Do not connect 3⁄8" white tubing from tank to faucet.
1
2
3
4
gasket
washer
quick connector
spacer
nut
