26
N Heater / Thermistor
1. Remove the rear lower access panel (B).
2. Remove the heater wiring and detach the thermistor plug.
3. Slacken off the 10 mm heater fixing nut and withdraw the heater from the drum.
O Drum Pulley
1. Remove the complete drum assembly (T).
2. Carefully peel the belt off the motor pulley taking care not to trap fingers.
3. Use the pulley locking tool to prevent rotation of the pulley.
4. Use a Torx T40 bit to partially remove the fixing screw in the centre of the pulley, and strike the
head of the screw with a copper mallet to release the pulley from the shaft.
5. To ensure adequate pulley security always apply an engineering Nutlock (Part No. 981009) to
the bolt threads.
P(a) Suspension Damper
1. Remove two suspension clamp fixing screws.
2. Remove the table top (A), dispenser drawer (C) and console panel (D).
3. Remove the door seal restraint (G), door interlock (H) and front panel (J).
4. Remove the lower balance weight (Ma) if access is required to the left-hand damper.
5. Unclip any wiring retained within the integral clip on the bottom damper moulding.
6. Remove the plastic peg securing the damper to the outer drum using special tool Part No.
5600198.
7. Unclip the suspension clamp from the chassis.
Withdraw the suspension damper.
Note: The suspension unit should not be split and is not serviceable.
8. When reassembling, fit a new plastic peg if the locking-tab on it shows signs of damage.
6 kg Welded Drum
Torque Setting 24 Nm
Sequence
Top Weight
1
2
3
Bottom Weight
1
2
3
2
1
3
Top Block
L
E
F
T
2
1
3
Bottom Block
L
E
F
T
