To ensure proper operation, please read this manual carefully.
Providing hot,normal& cold water.
The devices are compressor refrigeration
series. It is low energy consumption.
Quick-refrigerating and low noise.
The products are made of high quality raw
material: the hot water tank and heating tube are made of stainless steel.
Note:
Do not connect the electrical power plug until water comes out of the hot
water tap.
1)
Position the water dispenser out of direct sunlight and away from heat and
excessively damp place, leave an adequate open space (10cm
to
20cm) behand
the water dispenser for good ventilation.Do not position the water dispenser close
to expensive furniture or other electrical household appliances, as water spill can
cause serious problems.
2)
When carrying it,the angle of inclination should be less than 45
degree.
3)
Neither modify the power plug nor use an extensive cord,overheat or a fire could
result.
4)
Do not start or stop the heating or refrigerating process by plugging or unplugging
the power cord.
5)
Keep the water dispenser beyond the reach of children to avoid scald.
6)
Cleaning the water dispenser regularly with soft cloth. Do not wash the cabinet
with water. Do not wash the cabinet with gas or chemical medication as it can
damage the cabinet.
7)
The water tank should be sterilized periodically. The water and electricity supply to
the dispenser is shut off. Unscrew the screws (14) and lift the cover. Empty water
tanks through water drain(9). Fill the cold water tank with disinfectant solution and
wait about 30 minutes. Then empty the tank and open valve for water supply. After
the tanks are washed with fresh water, place the stopper and thread the drain plug
cap into the drain. Put the stopper and thread the cover of water drain. Connect
the dispenser to the power supply
.
WARNING:
-
Do not damage the refrigerant circuit.
-
If the supply cord is damaged, it must be replaced by manufacturer, its service
agent or similarly qualified persons in order to avoid hazard.
Installation
1)
Connect to the water source supply
(13)
. Press the hot water tap until water flows
out. Let flow 3-5 liters of water
2)
Plug the power cord to the wall outlet. Switch the heating and refrigerating
switches on, then the heating and refrigerating processes start to work.
7
General information
