4
function (a pressure regulator is not included in the delivery set and would need to be purchased
separately).
Locate the appropriate installation place for the clean water tip, working block, water conditioning
cartridge and a place for the connection node and drain saddle installation. Take care to ensure that the
delivery tubes are pulled freely, without excessive bending. Be mindful that the tubes should be placed where
they cannot be pulled out or damaged from foreign objects.
Fig. 5
Fig. 4
Fig. 3
Figure 2
RO must be located away from heat sources (such as cooking stoves, boilers, kitchen ovens, hot water pipes,
washing machines, dishwashers and etc.).
Install the storage tank in a safe place, where transfusion water over the edges may not lead to undesirable
consequences. It is typically recommended to place the storage tank in the sink when filling.
Connection node assembly (fig. 3)
• Turn the water off at the cold water main.
•
Open the kitchen faucet to relieve the pressure in the water
supply.
•
Connect the connection node to the plumbing.
Connect the JG 1/4” tube. To do this, pull the locking clip off
the plastic sleeve, install the plastic tube previously wetted with
water into connection node sleeve. Push it approximately 20 mm
up to the stop and put the clip back in its place.
Make sure that the tube (3) is tightened correctly: the tube
should not be pulled out by a force gr eater than 8–10 kgf (78–98 N).
Drain saddle installation (fig. 4)
•
Install the drain saddle into the drain line behind the siphon (drain saddle fits to the majority of the drain
lines with a diameter of approx. 40 mm). Please be sure to adhere to all local plumbing codes.
•
Remove the protective film off the gasket. Attach the gasket inside the saddle, so that the hole in the gasket
fits the saddle fitting.
•
Install the saddle on the drain line and then tighten the bolts. Bolts should be tightened evenly , so that the
two parts of the saddle are placed parallel to each other.
• Drill a 7 mm hole through the saddle fitting.
•
Put the nut on the free end of the JG drain tube (red color) then, when inserting the tube to the drain saddle
on 20–30 mm, put the nut on the fitting.
Figure 3
