28
1
2
3
EN
The J.SHMIDT 500 is designed for pre-purifica-
tion of water supplied by municipal water mains
and main sources of drinking water.
The water to be purified is poured into the fun-
nel (Figure 1). Then, the funnel is sealed with the lid.
Pressing the POWER BUTTON
(Figure 2),
starts the pneumatic compressor which increases
the air pressure inside the funnel. Then, the water
is forced by the pressure through the JS 500 re-
placement filter cartridge and thereby purified.
The compressor is powered by an internal bat-
tery, the charge level of which is indicated by the
LED indicator
BATTERY.
To help remind you about the need to replace
the filter cartridge, the system J.SHMIDT 500 fea-
tures a Remaining Filter Cartridge Life LED Indica-
tor labeled
FILTER
.
1.
Remove the J.SHMIDT 500 and its electronics
unit from the packaging.
2.
Remove the transporting insert from the fill
funnel. Make sure the float inside the funnel is
installed correctly. The float must be installed as
shown in Figure 3 and rotate freely around its
axis between the both end positions.
3.
Flush the body, funnel and the seal of the elec-
tronics unit with water.
CAUTION! Do not allow water to enter the
connector located on the electronics unit.
4.
Install the anti-slip pads (included) into the des-
ignated sockets located on the bottom of the
jug (remove the stands from the backing first).
5.
Install the filter cartridge. To do this, first re-
move the lid from the J.SHMIDT 500 and re-
move the funnel. Unpack the filter cartridge,
insert it into the opening of the funnel so that
the knobs on the cartridge match the notches
on the funnel, and rotate it as far as possible in
the direction shown in Figure 4.
6.
Assemble the J.SHMIDT 500 (Figure 5).
7.
Fill the funnel with water to the lower edge of
the neck (Figure 6).
CAUTION! The water level inside the funnel
must not exceed the lower edge of the neck.
DEVICE DESCRIPTION
PROCEDURE OF BEGINNING OF
OPERATION – PREPARATION OF USE
Electronics Unit
Lid
Funnel
Float
Jug Case
Filter Cartridge
Remaining Filter Cartridge
Life Indicator (
FILTER
)
Installation Site
Float
Battery Charge Level
Indicator (
BATTERY
)
Power Button (
)
Connector Ø3,5 × Ø1,3 mm
