`
ENGLISH
START-UP
When the filter has been loaded, the sand must be washed. Proceed as
follows:
1.- Place the selector valve in the " BACKWASH " position.
2.- Open the valves controlling the swimming pool suction pipes and run the
pump for 4 minutes.
3.- Stop the pump, place the handle of the selector valve into the "RINSE"
position and rinse for 1 min. Then, stop the pump and place the handle of
the selector valve into “FILTRATION” position.
When this has been done, the filter will be ready to start the filtering cycles
for the water in the swimming pool.
IMPORTANT: The pump should be switched off when the position
of the selector valve handle is being changed
.
MAINTENANCE
Do not use solvents for cleaning the filter, this could damage the filter,
especially its finish.
Always replace the joints and pieces that may not be in good condition.
Backwash and rinse when needed, as instructions specified in this manual.
Clean the sand every year for a better performance with solid or liquid
product. It’s recommended to change the sand inside the filter approximately
every 3 years.
Winter period:
In order not to damage the filter during the winter period, please follow the
instructions below:
Perform a backwash and a rinse as previously detailed.