26
Outputs
see Technical
output specifications on page 38 for more details
oX = o1 or o2
oX Volume
select when volume pulses are required (digital pulse)
oX Flow
select when flow is required (frequency)
oX Mass
select when mass pulses are required (digital pulse)
oX mFlo
select when mass flow is required (frequency)
oX Limit
select when a limit switch function is required
oX State
select when the status of the device is required
oX OFF
select to turn this output off
o2 Temp
select when temperature with an frequency output is required
AnA Flow
select when an analog current flow is required
AnA Temp
select when an analog current temperature is required
AnA mFlo
select when an analog current mass flow is required
AnA OFF
select to turn the analog off
Sim OFF
Simulation off, turn on to simulate individual outputs
Si 0.0000
enter a simulation value when simulation is on
Output settings
ms
pulse width limit in milliseconds
UPP
Units per pulse (the value of 1 pulse)
Act xx
the actual value on output
Min flow
lower flow rate value for frequency output (Qmin for o1/o2)
Min Hz
lower frequency value of frequency output (fmin for o1/o2)
Max flow
upper flow rate value of frequency output (Qmax for o1/o2)
Max Hz
upper frequency value of frequency output (fmax for o1/o2)
Err FmA
behavior during error of output (set to fMAX as defined in settings ( o1/o2 )
Err Act
behavior during error of output (actual value; error suppression)
Err Low
behavior during error of output (output signal is at low limit 3.5mA)
Err High
behavior during error of output (output signal is at high limit 21.5mA)
Min Limit
lower flow rate limiting value
Max Limit
upper flow rate limiting value
Hyst x%
hysteresis in percent of limiting value
Logic NO
logic function NO (normally open)
Logic NC
logic function NC (normally closed)
Activ
status of logic output is active
inActiv
status of logic output is inactive
Min °t
lower temperature value for frequency output (Tmin for o1/o2)
Min Hz
lower frequency value of frequency output (fmin for o1/o2)
Max °t
upper temperature value of frequency output (Tmax for o1/o2)
Max Hz
Upper frequency value of frequency output (fmax for o1/o2)
Min mA
lower value for the analog current signal of 4mA
(valid for flow, temp & mass flow)
Max mA
upper value of the analog current signal of 20mA
(valid for flow, temp & mass flow)
Summary of Contents for CONTOIL VZF II
Page 9: ...9...
