Thank you for purchasing Aqualogic
’
s Hydromate20. Following these guidelines will help
you to get the most from your product.
Hydromate Installation
Before commencing, if possible fill and flush the cistern, then isolate the water
supply. This will help when it comes to setup.
1.
Locate a section of the cistern supply pipe work that will accept the solenoid
valve.
2.
Decide on a location to site the Hydromate control box. Ideally this should be in
a position that ensures occupancy detection for the urinals only. The effective
sensing angle is up to 30˚ and the range up to 5 metres. The distance between
control box and solenoid valve can be up to 30 metres.
3.
Locate the stopcock/service valve for the water supply to the cistern and isolate.
4.
Install the solenoid valve(s) (observing the correct direction of flow marked on
the valve body).
5.
Make cable entry holes in back box and fit suitable cable glands if required.
6.
Mount the control back box in the desired position.
7.
Prepare the 3 core flex between the valve and control box, leaving surplus at
each end for connection.
8.
Disassemble the solenoid valve plug and using the 3 core flex and make connec-
tion between the valve plug and the terminal block marked
‘
valve
’.
Note: The valve will work in either polarity.
9.
The Hydromate 20 can operate up to 3 solenoid valves. A suitable junction box
will be required if installing multiple valves.
10.
Before connecting the 230v supply cable ensure a safe isolation procedure has
been followed*.
11.
NB: (*The electrical supply connections for this unit should only be carried out
by a competent and qualified electrician)
12.
Reinstate water supply and test for leaks.
Hydromate 20 Features Explained
Flush Frequency
. Set on Flush Program 1, the urinal will flush 30 minutes after
detecting the first user. Set on Flush Program 2, it will flush 40 mins after detecting
first user. This can be altered at any time after set up.
Hygiene Flush.
During periods of non occupancy the unit will perform a hygiene flush
every 24, 48 or 72 hours depending on program selected
Reset.
A reset button is located within the Hydromate this clears the memory ready
for reprogramming.
Lighting Control.
Upon detection the washroom lighting will remain on for a set time
