AquaLogic HydroMate 20 Installation & Setup Instructions Download Page 1

Page: 1 / 4

AQUHM20 1.2

HydroMate 20

Installation & Setup

Instructions

Please check your box has the following contents

You will require the following

1mm twin & earth flex

Cable Clips, Trunking or Conduit

20mm Cable glands, wall or ceiling

fixing Screws/plugs.

1 x Hydromate control standard surface mount

box.

1 x 15mm 230v Solenoid Valve.

URINAL CONTROL SYSTEMS

Recommended:

15mm isolation valve

“

AQRIV

”

(To comply with water regulations)

230v Supply from fused spur using 3 amp fuse (BS1361)

A wiring junction box

If connecting more than 1 valve to control unit

Summary of Contents for HydroMate 20

Page 1: ...Trunking or Conduit 20mm Cable glands wall or ceiling fixing Screws plugs 1 x Hydromate control standard surface mount box 1 x 15mm 230v Solenoid Valve URINAL CONTROL SYSTEMS Recommended 15mm isolatio...

Page 2: ...nd control box leaving surplus at each end for connection 8 Disassemble the solenoid valve plug and using the 3 core flex and make connec tion between the valve plug and the terminal block marked valv...

Page 3: ...Fill Time button once The solenoid valve will open and allow water to flow into the cistern Amber LED will flash while setting fill time When the cistern begins flushing press the Fill Time button ag...

Page 4: ...s Sw3 on adds 8 mins Sw4 on adds 16 mins 1 2 3 on up 15 minutes Lights on time delay Reprogramming Care 1 Should you require to increase or decrease flush frequencies simply adjust the rotary switch t...