Aqualisa MIDAS 110, Installation Instructions Manual

Page: 23 / 36

11
Place the wall fixing plate into position and mark and prepare the
fixing points using the fixings provided, if suitable. Secure the wall
fixing bracket to the wall using the screws provided, if suitable.
12
Ensuring the fixed head washer is in place, carefully screw the
shower head to the fixed riser arm taking care not to damage the
plated surface. Carefully tighten the shower head with a suitable
tool taking care not to overtighten.
13
Pass the bottom of the riser rail through the handset holder while
keeping the slider levers depressed. Ensure the handset holder
is in the correct orientation.
16
8
Ensuring the O-ring is in the correct position on the recess of the spigot section on the mounting plate, place
the wall outlet onto the mounting plate in the 5 o’clock position and rotate clockwise until a stop is
reached.
9
Refit the locking screw taking care not to over tighten
10
Drill and prepare two fixing points between 520mm (minimum) and 830mm
(maximum) apart using the fixings provided, if suitable.
11
Pass the rail through the handset holder while keeping the slider levers depressed.
!
The top rail end bracket can be adjusted to suit existing screw holes in the
finished wall by sliding the bracket up or down the rail to suit the required
position.
12
Carefully slide the gel hook onto the rail under the handset holder.
!
Current Water Supply regulations state that the handset should not be allowed to pass a point 25mm
above the spill over level of the bath or shower tray. If this cannot be achieved, the hose must be
passed through the gel hook which has been designed to be utilised as a hose restraint.
13
Secure the top rail bracket into position using the screws provided, if suitable.
14
Attach the bottom rail end body onto the rail.
14
Re-position the riser rail assembly onto the mixer valve outlet.
Tighten the fixing nut using a suitable tool, taking care not to
overtighten.
23