AQUACLAVE Manual Flushing Membrane System
Installation instructions
11
A.
With everything connected,
SLOWLY TURN ON THE WATER AND
CHECK FOR LEAKS.
B.
Make sure the storage tank shut-off valve is “OFF”. Open the sink top
faucet.
C.
Within a few minutes (up to 15) the water will start to run from the faucet
slowly.
D.
Let the water run for at least 30 minutes. This flushes the carbon filters
on first time use.
CLOSE FAUCET AND AGAIN CHECK FOR LEAKS.
E.
After initial flushing, open the shut-off valve on the tank and close the
sink top faucet.
F.
Tank will now be full of water (usually 5 to 6 hours). Open the sink top
faucet and drain all water until the storage tank is empty and there is
only a small flow from the sink top faucet.
***DO NOT USE FIRST TANK OF WATER.***
G.
Close the sink top faucet. The system is now ready for use.
H.
Change filters regularly every 6 months and have the membrane
checked annually.
Caution
1.
Do not use hot water (over 45°C)
2.
Do not allow the system to freeze
3.
Switch off electricity and water source if away for more than
5 days, and drain the tank
